Steering and power supply

Radio switches single channel

Signal receivers are used to wirelessly switch on and off following devices.

SignalControllers may operate in five modes:

  • Bistable – device is alternately switched on and off using a single button.
  • Time control – pressing the button causes device to switch on for a time period programmed by the user, after which it is switched off again.
  • Switch On – device is switched on when the button is pressed.
  • Switch Off – device is switched off when the button is pressed.
  • Monostable – device is switched on for the time when button remains pressed (this mode is not recommended). receivers are used to wirelessly switch on and off following devices.

Switching controlled devices on and off:

Product code ROM-01 ROP-01
Mounting on TS-35 rail under surface
Voltage [V / Hz] 230/50
Nominal power [W] 0,45 0,29
Transmission [MHz] 868, 32

Steering and power supply

PRO Remote control

PRO-type remote controls are intended to replace mobile phone, tablet or PC computer in communication with the ERO-32WS-0 controller.

PRO-type remote control allows to increase and decrease rotating speed of the controlled device in a simple way. Also various different functions may be assigned to remote control buttons, i.e.:

  • incremental increase of rotating speed
  • setting a fixed value of rotating speed
  • switching the controlled device on and off

Remote control is compatible with smart building solutions offered by the company BleBox. Is compatible with ERO-32WS-0 control.

Product code PRO
Transmission [GHz] 2, 4
Power supply Lithium polymer battery
Charging Standard micro USB charger

Steering and power supply

Thermostats

Thermostats are sensors used to switch the controlled devices on and off according to temperature set by the user.

Thermostats TERMO and TERMO-AT may also be used as sensors with digital (bistable) output, that may be connected with ERO-32AP-0 type controllers (operating modes: fixed sensor mode, zonal sensor mode). Usage:

Type TERMO TERMO-AT
Adjustment range  [ºC] – 0 – + 150
Capilary lenght [m] 1

Steering and power supply

Thermal probe KTY84

KTY84 is a thermal probe designed for temperature measurement of hot air inside the fireplace hood.

KTY84 is a thermal probe designed for temperature measurement of hot air inside the fireplace hood. Probe with analogue output, compatible with following controllers:

Product code KTY84
Range of temperature measured   [ºC] – 40 – + 150
Cable lenght [m] 2